How to finish the quilt - The facing method

The face binding method hides the quilt's raw edges while freeing the quilt design from the visual binding's frame. It is very useful for the wall hanging quilts, but it can be used for any type of modern quilt. It also reduces bulk in the corners, and provides nice clean turned edges.There are several ways of doing it. I will show you how I did it.

Facing the quilt with hanging corners

I used the same tools I use for binding.

1. I trimmed the quilt. I measured the length and the width of the quilt (approx. 85" x 102). 

2. For each of the four quilt edges I prepared four strips of fabric 2 ½" wide and 3" shorter than each side of the quilt. In my case – (2) 2 ½" x 82" and (2) 2 ½" x 99" (you might keep the strip uncut and trim it when sewing, right before you get to the quilt corner). For each corner of the quilt I cut four 5" squares. 

3. I folded in half lengthwise right side out the four strips and pressed them with iron. I folded each square diagonally in half right side out to make triangles and pressed them. 

4. I placed the quilt on a flat surface (floor) with the top facing up. I pinned the four triangles in each corner of the quilt with the raw edges of the triangles aligned with the raw edges of the quilt. I stitched the corners in place with ¼ " seam allowance.

 

5. I centered and pinned the four folded strips along each corresponding side of the quilt, on top of the triangles, with the raw edges aligned with the raw edges of the quilt, leaving a 1 ½" gap at each corner of the quilt. 

6. I stitched all the way around the edge of the quilt with a ¼' seam allowance, overlapping the corner seam lines. 

If  you use a continuous strip, trim it right before you get to the quilt corner

I clipped the four corners avoiding the seams.

7.  I flipped the triangles to the back and, with a pen with the cap on, I carefully pushed all the corners out to give them a nice finish. I pressed the triangles in place. I pressed the strips away from the quilt. Then I folded, pressed them with steam to the back side of the quilt, having about 1/16″ of quilt front showing on the back.

9. Keeping the quilt with the top up, I stitched by machine all the way around at 7/8 of an inch away of the quilt edges (the facing strips are 1" wide) to secure the strips to the back of the quilt. If you want that the stitching to be invisible on the quilt top, stitch the strips to the back of the quilt by hand.

I hope you find this post helpful. 

I used this method to finish a quilt made from old jeans and men's shirts, following the instructions of "Meeting with friends" quilt pattern.

Have a beautiful sewing day, my dears!